128k ISDN, help needed

[spider1]

Ok I have recently got HH installed and got myself a Diva 128k, pci ISDN card.

I can setup all the dial-up multilink crap for both channels and actually connect at 128k, but when I do my connection just sits there, and occasionally I get about 50 bytes, thats all though.

Does anyone have any ideas about what could be going wrong?

thanx

[Spidery]

Go to Start>Run> then type 'Winipcfg' without the commas. If it doesn't show a number in the default gateway box, then it means your 2 channels have been routed to different places around the country. This is because of BT's routers, and it depends on where u live, if you have this problem or not. My advice is to reconnect A LOT. This problem is usually a lot worse at peak times.

Hope that helps :smokin:

[Edited by Spidery on 16-09-2000 at 11:28 AM]

[Spidery]

And by the way, nice to meet a fellow Arachnid :)