M/b suggestions for GForce2 GTS 64mb

[[TSQN]RedKite]

Would appreciate suggestions for upgrading my current m/b, which only supports AGPx1 though it should support x2.
Currently i'm running a 600 athlon, 256ram, 20gb h/d.
I'm sticking with the 600 athlon for the moment, but will be looking to significantly upgrade that at some point as well.
Compatabilty with the GTS is a must, but i'm not bothered too much about overclocking.
So stabilty and performance are the key words, cost is not an issue.
What d'yer reckon :)

[The Laughing Cow]

is that original slot A athlon? or new Socket A?

for socket A id totally recommend the Abit KT7. i dont know much about slot A but i believe the Abit (i think) KA7 is good.

HTH!

[Calzor Suzay]

Scan (http://www.scan.co.uk/today.htm) have the board on special today at £109+vat, you got till 5.30pm to call'em but it'll probably come round again on special a week or so later :E

[NumbNutz]

My 'pooter is built round the ABIT KT7 RAID and it's a fine, if somewhat awkward, piece of kit. I'd consider this or the ASUS A7V board. Both boards have an awfull lot of life left in them.

[[TSQN]RedKite]

Thanks for the input guys, my old cpu was a slot A, i say was, cos it's all gone back to Evesham under warranty, and i'm going for a Chaintech 7AJA which means they've gotta change the cpu as well to a Socket A Thunderbird :)(yummy)
The 7AJA has a good stabilty record and version 686b is a clockers dreamboat.
Thanks again :D